[36] PARKING BRAKES - - PARKING BRAKE PEDAL <R.H. drive vehicles> - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
PARKING BRAKE PEDAL <R.H. drive vehicles>
REMOVAL AND INSTALLATION
Pre-removal Operation
  • Console side cover <driver's side> removal (Refer to GROUP 52A, Instrument Panel Assembly ).
  • Foot duct <driver's side> removal (Refer to GROUP 55A, Heater unit, Heater Core, Heater Blower Assembly and Evaporator Unit ).
Post-installation Operation
  • Foot duct <driver's side> installation (Refer to GROUP 55A, Heater unit, Heater Core, Heater Blower Assembly and Evaporator Unit ).
  • Console side cover <driver's side> installation (Refer to GROUP 52A, Instrument Panel Assembly ).
  • Parking Brake Pedal Stroke Adjustment (Refer to ).

   



Removal steps


1.
 Adjusting nut


2.
 Nut holder


3.
 Parking brake pedal assembly


4.
 Sealer


5.
 Pedal pad


6.
 Parking brake switch

>>A<<
 7.
 Tension spring


8.
 Stopper


9.
 Parking brake pedal assembly

INSTALLATION SERVICE POINT
>>A<< TENSION SPRING INSTALLATION
   
Apply grease to the mating surface of the tension spring and pedal, and then install the spring as shown.
[36] PARKING BRAKES - - PARKING BRAKE PEDAL <R.H. drive vehicles> - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation