Pre-removal Operation
|
Post-installation Operation
|
)
| Power window switch removal steps |
|||
|---|---|---|---|
>>B<< |
• |
Post-installation operation check <Vehicles for Argentina> |
|
| 1. |
Power window switch (Refer to GROUP 52A, Door trim  .) |
||
| Door window regulator assembly removal
steps |
|||
| >>B<< |
• |
Post-installation operation check <Vehicles for Argentina> |
|
| <<A>> |
>>A<< |
2. |
Window regulator assembly |
| <<A>> |
3. |
Power window motor assembly |
|
| Door window glass removal steps |
|||
| • |
Window glass runchannel <Rear door>
(Refer to .) |
||
| • |
Lower sash <rear door>
(Refer to .) |
||
| • |
Door latch assembly <Rear door>
(Refer to .) |
||
| • |
Door beltline molding (Refer to .) |
||
| • |
Door beltline inner weatherstrip (Refer to .) |
||
| 4. |
Door window glass |
||
REMOVAL SERVICE POINT
CAUTION)
- Lift the door window glass, and attach special tool window glass holder (MB990480) to the glass as shown to prevent the glass from falling.
- Remove the window regulator assembly and power window motor assembly.
INSTALLATION SERVICE POINTS
)
When installing the window regulator assembly, tighten the bolts to the specified torque
in the order shown.