RESISTER CHECK
)
Use an ohmmeter to measure the resistance between the terminals. Check that the measured value is at the standard value.
Standard value:
| Measurement terminal |
Standard value (Ω) |
|---|---|
| Between terminals 2 and 4 (LO) |
2.54 |
| Between terminals 1 and 2 (ML) |
1.24 |
| Between terminals 2 and 3 (MH) |
0.6 |
BLOWER FAN AND MOTOR CHECK
)
When battery voltage is applied between the terminals, check that the motor operates. Also, check that there is no abnormal noise.
OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR CHECK <LH drive vehicles>
)
CAUTION| Lever position |
Battery connection |
Lever operation |
|---|---|---|
| At the inside position |
|
The lever moves from the inside position to the outside position |
| At the outside position |
|
The lever moves from the outside position to the inside position |
OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR CHECK <RH drive vehicles>
CAUTION| Lever position |
Battery connection |
Lever operation |
|---|---|---|
| At the inside position |
|
The lever moves from the inside position to the outside position |
| At the outside position |
|
The lever moves from the outside position to the inside position |