[55A] HEATER, AIR CONDITIONER AND VENTILATION - - EVAPORATOR ASSEMBLY - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
EVAPORATOR ASSEMBLY
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
  • Refrigerant draining and Refilling (Refer to Charging and Discharging ).
  • Air cleaner cover and air flow sensor assembly Removal and Installation (Refer to GROUP 15, Air cleaner <2400-except MIVEC>, <2400-MIVEC>).

       



Removal steps
<<A>>
1.
 Flexible suction hose connection
<<A>>
2.
 Liquid pipe B connection
<<A>>
3.
 Expansion valve cover
<<A>>
4.
 Expansion valve
<<A>>
5.
 Joint


6.
 O ring


•
 Glove box (Refer to GROUP 52A, Instrument Panel <L.H. drive vehicles>, <R.H. drive vehicles>).


7.
 Joint duct


•
 Foot duct <driver's side>


9.
 Front floor console lower side cover
    10.
 Evaporator cover


11.
 Air thermo sensor clip


12.
 Air thermo sensor
    13.
 Evaporator

REMOVAL SERVICE POINT
<<A>> FLEXIBLE SUCTION HOSE AND LIQUID PIPE B DISCONNECTION
 CAUTION
 As the compressor oil and receiver are highly moisture absorbent, use a non-porous material to plug the hose and nipples.
To prevent the entry of dust or other foreign bodies, plug the dismantled hose and the nipples of the expansion valves.
[55A] HEATER, AIR CONDITIONER AND VENTILATION - - EVAPORATOR ASSEMBLY - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation