)
)
Use the special tool to remove the self-locking nut.
- Special spanner (MB991367)
- Pin (MB991386)
)
Line up the pin hole on the compressor unit with the field core projection and attach.
)
Using snap ring pliers, fit the snap ring so that the snap ring’s tapered part is on the outside.
Use the special tool to install the self-locking nut.
- Special spanner (MB991367)
- Pin (MB991386)
)
Apply voltage from the battery to the magnetic clutch and check that the clutch air gap is inside the standard value. If outside the standard value, use a shim to adjust the gap.
Standard value: 0.3 -
0.5 mm