[55B] AUTOMATIC AIR CONDITIONER - - CONDENSER AND CONDENSER FAN MOTOR - REMOVAL AND INSTALLATION <2000-SOHC>PRINT PAGE / INDEX / PRIOR / NEXT
REMOVAL AND INSTALLATION <2000-SOHC>
Pre-removal and Post-installation Operation
  • Refrigerant draining and Refilling (Refer to Charging and Discharging ).
  • Air cleaner cover and air flow sensor assembly Removal and Installation (Refer to GROUP 15, Air cleaner ).

   



Condenser removal steps
<<A>>
1.
 Liquid pipe A connection
<<A>>
2.
 Flexible discharge hose connection


3.
 O ring

>>A<<
 4.
 Condenser assembly


5.
 Receiver


6.
 Clamp


7.
 O ring


8.
 Condenser



Fan shroud assembly removal steps
 
9.
 Fan shroud assembly
 
10.
 Fan


11.
 Fan motor


12.
 Fan shroud



Air guide panel removal steps


•
 Front bumper (Refer to 51, Front bumper ).


13.
 Air guide panel

REMOVAL SERVICE POINT
<<A>> FLEXIBLE SUCTION HOSE AND LIQUID PIPE A DISCONNECTION
 CAUTION
 As the compressor oil and receiver are highly moisture absorbent, use a non-porous material to plug the hose and nipples.
To prevent the entry of dust or other foreign bodies, plug the dismantled hose and condenser assembly nipples.
INSTALLATION SERVICE POINT
>>A<< CONDENSER INSTALLATION
When replacing the condenser, refill it with a specified amount of compressor oil and install it. (to the vehicle).
Compressor oil: SUN PAG 56
Quantity: 15 mL
[55B] AUTOMATIC AIR CONDITIONER - - CONDENSER AND CONDENSER FAN MOTOR - REMOVAL AND INSTALLATION <2000-SOHC>PRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation