CHECK THE AIR MIXING DOOR CONTROL MOTOR AND POTENTIOMETER
)
| Battery connection (+) terminal |
Battery connection (-) terminal |
Lever operation |
| 1 |
3 |
Rotate to the HOT position. |
| 3 |
1 |
Rotate to the COOL position. |
- When the resistances between terminals 2 and 5 as well as terminals 5 and 6 are measured at the air mixing door motor check, the resistance value should change gradually within the standard value.
Potentiometer check
Standard value: Approximately 0.65(MAX COOL) -
5.35(MAX HOT) kΩ
MODE SELECTION DAMPER CONTROL MOTOR AND POTENTIOMETER CHECK
)
| Battery connection (+) terminal |
Battery connection (-) terminal |
Lever operation |
| 1 |
3 |
Rotate to the DEF position. |
| 3 |
1 |
Rotate to the FACE position. |
- When the resistances between terminals 2 and 5 as well as terminals 5 and 6 are measured at the mode selection damper control motor check, the resistance value should change gradually within the standard value.
Potentiometer check
Standard value: Approximately 0.65(DEF position) -
5.35(FACE position) kΩ
BLOWER MOTOR CHECK
Execute actuator test item No.01 to 04 by using MUT-II with the vehicle body, and check that the blower motor works normally (Refer to 
).