|
|
BATTERY TESTING PROCEDURE
|
STEP 1. Check the battery cables.
Remove the negative cable, then the positive cable.
Check for dirty or corroded connections.
Q: Are the battery cables dirty or have corroded connections?
YES:
Clean the battery cables. Then go to Step 2  .
NO:
Go to Step 2  .
|
STEP 2. Check the battery post.
Check for loose battery post.
Q: Are the battery post faulty?
YES:
Replace the battery. Then go to Step 4  .
NO:
Go to Step 3  .
|
STEP 3. Check the battery case and cover.
- Remove the hold-downs and shields.
- Check for broken/cracked case or cover.
Q: Is the battery case or cover faulty?
YES:
Replace the battery. Then go to Step 4  .
NO:
Go to Step 4  .
|
STEP 4. Check the open circuit voltage.
- Turn headlamps on for 15 seconds.
- Turn headlamps off for two minutes to allow battery positive voltage to stabilize.
- Disconnect the battery cables.
- Read open circuit voltage.
Q: Is open circuit voltage 12.4 volts or more?
YES:
Go to Step 5  .
NO:
Charge the battery at 5 amps for 15 hours. Then re-test.
|
STEP 5. Check the load test.
- Connect a load tester to the battery.
- Load the battery at the recommended discharge rate (See LOAD TEST RATE CHART) for 15 seconds.
- Read voltage after 15 seconds, then remove load.
- Compare the measured value with the minimum voltage (See LOAD TEST CHART).
Q: Is the voltage higher than minimum voltage?
YES:
The battery is normal.
NO:
Replace the battery. Then go to Step 4  .
|
LOAD TEST CHART
Temperature °C
|
21 and above
|
16
|
10
|
4
|
-1
|
-7
|
-12
|
-18
|
Minimum voltage
|
9.6
|
9.5
|
9.4
|
9.3
|
9.1
|
8.9
|
8.7
|
8.5
|
|
LOAD TEST RATE CHART
Battery type
|
44B20L <Vehicles for Hong Kong, Brunei, Singapore, Malaysia>
|
75D23L <Vehicles for General Export (except for Hong Kong, Brunei, Singapore, Malaysia), GCC, Australia and New zealand (2400)>
<Option for Hong Kong, Brunei, Singapore, Malaysia>
|
Charging time when fully discharged h (5-anp. rated current charging)
|
7
|
11
|
Load test (Amps)
|
215
|
275
|
|