|
| |
| |
| Headlamp bulb <low-beam>
 CAUTION
Do not touch the bulb surface bare-handed or with dirty gloves. If dirt is attached on surface of the bulb, immediately use alcohol or thinner to remove dirt, and install the bulb after well dried.
- Disconnect the headlamp connector.
|
|
- Screw out the headlamp socket.
- Replace the valve, and connect securely the connector.
|
| Headlamp bulb <high-beam>
CAUTION
Do not touch the bulb surface bare-handed or with dirty gloves. If dirt is attached on surface of the bulb, immediately use alcohol or thinner to remove dirt, and install the bulb after well dried.
- Disconnect the headlamp connector.
|
|
- Twist the socket to withdraw the bulb.
- Replace the valve, and connect securely the connector.
|
| Position lamp bulb
CAUTION
Do not touch the bulb surface bare-handed or with dirty gloves. If dirt is attached on surface of the bulb, immediately use alcohol or thinner to remove dirt, and install the bulb after well dried.
|
|
Disconnect the connector, and twist the position lamp socket to remove it.
|
| |
| |
|
CAUTION
Do not touch the surface of the bulb with hands or dirty gloves as the bulb may pop after a short time. If the surface does become dirty, clean it with alcohol or thinner, and let it dry thoroughly before installing.
- Disconnect the connector.
- Remove the socket cover.
|
|
- Release the bulb securing spring, and remove the bulb.
- Replace the valve, and connect the connector securely.
|
| Headlamp bulb (high beam)
|
|
CAUTION
Do not touch the surface of the bulb with hands or dirty gloves as the bulb may pop after a short time. If the surface does become dirty, clean it with alcohol or thinner, and let it dry thoroughly before installing.
- Disconnect the connector.
- Twist the socket to withdraw the bulb.
- Replace the valve, and connect the connector securely.
|
| Position lamp bulb
CAUTION
Do not touch the bulb surface bare-handed or with dirty gloves. If dirt is attached on surface of the bulb, immediately use alcohol or thinner to remove dirt, and install the bulb after well dried.
|
|
- Twist the socket to withdraw the bulb.
- Replace the valve, and connect the connector securely.
|
| Front turn-signal lamp bulb
CAUTION
Do not touch the bulb surface bare-handed or with dirty gloves. If dirt is attached on surface of the bulb, immediately use alcohol or thinner to remove dirt, and install the bulb after well dried.
|
|
- Twist the socket to withdraw the bulb.
- Replace the valve, and connect the connector securely.
|
)
)
)
)
)
)
)
)