STEP 2. Check how a CD is inserted.
- Ensure that the ignition switch is at "ACC" or "ON".
NOTE: If you try to load a CD when the ignition switch is at the positions other than "ACC" or "ON", the CD will not be inserted completely and then rejected.
Q: If you try to load the CD, does the CD stops halfway and then rejected?
YES:
Refer to INSPECTION PROCEDURE 30 
.NO: Go to Step 3.
STEP3. Check after the CD is loaded.
NOTE: Even though the CD is loaded, "E" (error) is sometimes displayed with the CD rejected because of vibration/shock or dew on the CD face or optical lens.
Q: Though the CD is inserted completely, is "E" (error) displayed and the CD ejected?
YES:
Go to Step 4.NO: The procedure is complete.
STEP 5. Check again using a normal CD, which is not dirty or scratched.
- Load another normal CD.
- Check that the CD player recognizes and play the CD.
Q: When you substitute another normal CD, is the CD loaded correctly?
YES:
The original CD is defective. Check that a CD can be inserted.NO: Replace the radio with CD player. The procedure is complete.