)
- Place the front wheel on a turning radius gauge and measure the steering angle.
Standard value:
| ITEMS |
2000 |
2400 |
|---|---|---|
| Inside wheel |
34°20'
±
1°30' |
34°50'
±
1°30' |
| Outside wheel (reference) |
29°10' |
29°20' |
- If the steering angle is not within the standard value, adjust the toe-in as follows.
Standard value: 1 ±
2 mm
)
- Loosen the jam nut, and unclip the bellows.
- Adjust the toe-in by turning the left and right tie rod turnbuckles by the same amount (in opposite directions).
NOTE: The toe will move out as the left turnbuckle is turned toward the front of the vehicle and the right turnbuckle is turned toward the rear of the vehicle.
- Tighten the jam nut to the specified torque, and tighten the bellows by the clip.
Tightening torque: 52 ±
2 N·m
- Recheck the steering angle.