Pre-removal Operation
|
Post-installation Operation
|
<2000 and 2400 (Except MIVEC)>
)
| Removal steps |
|||
|---|---|---|---|
| 1. |
Pressure switch connector |
||
| 2. |
Drive belt (Refer to GROUP 11A, Engine assembly  <2000-SOHC
and 2400 (Except MIVEC)>, Refer to GROUP 11C, Engine assembly <2000-DOHC>.) |
||
>>A<< |
3. |
Suction hose |
|
| 4. |
Pressure hose |
||
| <<A>> |
5. |
Oil pump assembly |
|
| 6. |
A/C compressor harness |
||
| 7. |
Power steering pump bracket |
<2400 (MIVEC)>
)
| REMOVAL STEPS |
|||
|---|---|---|---|
| 1. |
Drive belt (Refer to GROUP 11E, Engine assembly .) |
||
| >>A<< |
2. |
Suction hose |
|
| 3. |
Pressure switch connector |
||
| 4. |
Pressure hose |
||
| 5. |
Power steering oil pressure sensor harness clamp |
||
| 6. |
Control wiring harness clamp |
||
| 7. |
Battery wiring harness clamp |
||
| 8. |
Engine oil dipstick and dipstick guide |
||
| 9. |
O-ring |
||
| 10. |
Oil pump and bracket assembly |
||
| 11. |
Bracket |
||
| <<A>> |
12. |
Oil pump assembly |
)
)
Install the suction hose so that the marking is positioned as shown in the illustration.