Pre-removal and Post-installation Operation
|
<2400 (Except MIVEC)>
)
| Removal steps |
|||
|---|---|---|---|
| 1. |
Oil reservoir |
||
>>F<< |
2. |
Return hose |
|
| >>E<< |
3. |
Suction hose |
|
| >>D<< |
4. |
Return hose |
|
| >>C<< |
5. |
Return hose |
|
| >>B<< |
6. |
Return hose |
|
| 7. |
Return tube assembly |
||
| • |
Front bumper assembly (Refer to GROUP 51, Front Bumper Assembly  <2400>). |
||
| 8. |
Cooler tube assembly |
||
| • |
Tie rod end and knuckle connection (Refer to ). |
||
| • |
Stabilizer link (Refer to GROUP 33, Stabilizer Bar <2000-DOHC
and 2400 >). |
||
| >>A<< |
9. |
Return hose |
|
| 10. |
Return tube |
||
| 11. |
O-ring |
||
| 12. |
Eye bolt |
||
| 13. |
Gasket |
||
| 14. |
Pressure hose assembly |
||
| 15. |
Return tube |
<2400 (MIVEC)>
)
| Removal steps |
|||
|---|---|---|---|
| 1. |
Oil reservoir |
||
| >>F<< |
2. |
Return hose |
|
| >>E<< |
3. |
Suction hose |
|
| >>D<< |
4. |
Return hose |
|
| >>C<< |
5. |
Return hose |
|
| >>B<< |
6. |
Return hose |
|
| 7. |
Return tube assembly |
||
| • |
Front bumper assembly (Refer to GROUP 51, Front Bumper Assembly <2400>). |
||
| 8. |
Cooler tube assembly |
||
| • |
Tie rod end and knuckle connection (Refer to ). |
||
| • |
Stabilizer link (Refer to GROUP 33, Stabilizer Bar <2000-DOHC
and 2400 >). |
||
| >>A<< |
9. |
Return hose |
|
| 10. |
Return tube |
||
| 11. |
O-ring |
||
| 12. |
Eye bolt |
||
| 13. |
Gasket |
||
| 14. |
Pressure hose assembly |
||
| 15. |
Return tube |
)
Install the return hose so that the marking is positioned as shown in the illustration.
)
)
Install the return hose so that the marking is positioned as shown in the illustration.
)
Install the return hose so that the marking is positioned as shown in the illustration.
)
Install the return hose so that the markings are positioned as shown in the illustration.
)
)
Install the suction hose so that the marking is positioned as shown in the illustration.
)
Install the return hose so that the markings are positioned as shown in the illustration.