[37] POWER STEERING - - POWER STEERING GEAR BOX AND LINKAGE - TIE ROD END BALL JOINT DUST COVER REPLACEMENTPRINT PAGE / INDEX / PRIOR / NEXT
TIE ROD END BALL JOINT DUST COVER REPLACEMENT
If the dust cover is damaged accidentally during service work, replace the dust cover as follows:
       
    1. Apply specified grease to the lip and inside of the dust cover.
      2. Specified grease:
      • Multipurpose grease SAE J310, NLGI No.2 or equivalent
    1. Drive in the dust cover with special tool front axle base (MB990776) until it is fully seated.
    1. Check the dust cover for cracks or damage by pushing it with your finger.
    [37] POWER STEERING - - POWER STEERING GEAR BOX AND LINKAGE - TIE ROD END BALL JOINT DUST COVER REPLACEMENTPRINT PAGE / INDEX / PRIOR / NEXT
    ©2004 Mitsubishi Motors Corporation