[34] REAR SUSPENSION - - REAR SUSPENSION CROSSMEMBER - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
REAR SUSPENSION CROSSMEMBER
REMOVAL AND INSTALLATION
Pre-removal Operation
  • Main Muffler, Centre Exhaust Pipe Removal (Refer to GROUP 15, Exhaust pipe and Main Muffler ).
  • Control Link, Upper Arm, Lower Arm Removal (Refer to ).
  • Stabilizer Bar Removal (Refer to ).
  • Fuel Filler Neck Protector Removal (Except for Brazil and Chile, refer to GROUP 13D, Fuel Tank ). (For Brazil and Chile, refer to GROUP 13D, Fuel Tank ).
Post-installation Operation
  • Fuel Filler Neck Protector Installation (Except for Brazil and Chile, refer to GROUP 13D, Fuel Tank ). (For Brazil and Chile, refer to GROUP 13D, Fuel Tank ).
  • Stabilizer Bar Installation (Refer to ).
  • Control Link, Upper Arm, Lower Arm Installation (Refer to ).
  • Main Muffler, Centre Exhaust Pipe Installation (Refer to GROUP 15, Exhaust pipe and Main Muffler ).
  • Rear Wheel Alignment Check and Adjustment (Refer to ).

<2000>
   



Removal steps


1.
 Dynamic damper <4WD>


2.
 Differential support arm connecting bolt <4WD>


3.
 Rear suspension crossmember


4.
 Differential support arm <4WD>


5.
 Plug

   
<2400>
   



Removal steps


1.
 Dynamic damper


2.
 Differential support arm connecting bolt


3.
 Rear suspension crossmember


4.
 Differential support arm


5.
 Plug

[34] REAR SUSPENSION - - REAR SUSPENSION CROSSMEMBER - REMOVAL AND INSTALLATIONPRINT PAGE / INDEX / PRIOR / NEXT
©2004 Mitsubishi Motors Corporation