LOWER ARM BUSHING AND LOWER ARM PILLOW BALL BUSHING REPLACEMENT

[34] REAR SUSPENSION - - CONTROL LINK, UPPER ARM AND LOWER ARM - LOWER ARM BUSHING AND LOWER ARM PILLOW BALL BUSHING REPLACEMENT


	LOWER ARM BUSHING AND LOWER ARM PILLOW BALL BUSHING REPLACEMENT

	Replace the lower arm bushing and lower arm pillow ball bushing as follows.

	LOWER ARM BUSHING REPLACEMENT CAUTION Because the outside of both edges of the bushing are different, be careful not to mistake the direction.
	Use following special tools to drive out and press fit the bushing. MB991447: Bushing Remover and Installer MB991448: Bushing Remover and Installer Base MB991449: Bushing Remover and Installer Supporter After press fitting, the space between the edges of the bushing outer sleeve and of the lower arm should be 1.5 mm.

	LOWER ARM PILLOW BALL BUSHING REPLACEMENT
	Use following special tools to drive out and press fit the bushing. MB990957: Lower Arm Bushing Remover and Installer MB990969: Guide MB990971: Base MB990996: Lower Arm Bushing Arbor After press fitting, the space between the edges of the bushing outer sleeve and of the lower arm should be 3 mm.

[34] REAR SUSPENSION - - CONTROL LINK, UPPER ARM AND LOWER ARM - LOWER ARM BUSHING AND LOWER ARM PILLOW BALL BUSHING REPLACEMENT